Call +82-31-1577 - 8898

Air environmental Plants

Model CTS
Use Removal of VOCs, Fume, Mist, fusible gas, liquid drop
Filter type Filling material, Water, Eliminator

Introduction

  • Wet type processing facility
    CTS-Series scrubber is a facility to remove VOCs, fume and mist by wet method.
    It is used to collect fusible gas as NH, HCI, H₂S. It cleans the dirty gas by liquid drop, liquid film and bubble.
    The particles are attached, accelerated to be condensed and separated from the direct flow of gas.
    Cleaning water needs the waste water treatment because reactivate organism is
    discharged by aqueous solution.
    It can be used for removal of distillation, dust and mist.
  • Kinds of scrubber
    • Packed Tower
    • Bubble cap Tower
    • P&ID

    • There is a difference by the type, filling material and the depth of packed x-x-x-x-x-x-x-layer, but the pressure loss is about 100~250 mmH₂O and the water consumption is about 2~3 ℓ /㎥.
    • 1~1/2 inch smooth surface filling material is in the packed x-x-x-x-x-x-x-layer to clean by enlarging the surface of dirty gas and liquid.

    It is a kind of tray tower, and the air distributer called as bubble cap is installed for each tray.
    The air becomes a bubble after passing through the bubble cap and spouts to contact the air to the liquid.
    The liquid is moved parallel on the tray and flows to the below through the descending pipe.
    The efficiency is relatively fine. It has advantage on large volume of processing and is commonly used in the industrial field.

    This is basic design P&ID(Piping and instrumentation diagram).

    Application case for unusual gas
    - EO gas processing / Lotte Engineering & Construction Co., Ltd.
    - AN gas processing / LG Chem, Ltd.

    This is a P&ID of scrubber that basically removes the gas. Small amount of dust can be removed by additional separator in front of scrubber.

    This is a P&ID of scrubber installed in back of activated carbon regenerator of 1st factory, CJ CheilJedang.

    The packing material which is basically in each x-x-x-x-x-x-x-layer of scrubber is not suitable for removing dust because of blockage.
    However, 2-1 Scrubber is designed with water x-x-x-x-x-x-x-layer, not the packing material. It can remove the dust by running water design that the pollutants are removed by collision with water x-x-x-x-x-x-x-layer when the dirty gas arise .

Applications

  • • Workplace that need to remove the water soluble VOCs as chemical factory, plating factory and PCB factory.